IMCInter Module Communication
v5.5.11

Command To Follow

Command ID 497
Payload
13 bytes
Packet
35 bytes
Source
ccu, vehicle
Category
Maneuvering

This message must be sent by an external entity to provide command references to a system running a "Follow Command Maneuver". If no Command messages are transmitted, the system will terminate maneuver.

#Fields

Offset FieldTypeUnitRangeDescription
0 #flagsFlags uint8_t Bitfield –
0x01FLAG_SPEED_METERS_PSUse Speed Reference in meters per second

Command system to move at speed reference provided in "speed" field in meters per second.

0x02FLAG_SPEED_RPMUse Speed Reference in revolutions per minute

Command system to move at speed reference provided in "speed" field in revolutions per minute.

0x04FLAG_DEPTHUse Z Reference as depth

Command system to move at z reference provided in "z" field in depth.

0x08FLAG_ALTITUDEUse Z Reference as altitude

Command system to move at z reference provided in "z" field in altitude.

0x10FLAG_HEADINGUse Heading Reference

Command system to move at a heading reference provided in "heading" field in radians.

0x20FLAG_HEADING_RATEUse Heading Rate Reference

Command system to move at a heading rate reference provided in "heading" field in radians/s.

0x80FLAG_MANDONEFlag Maneuver Completion

Command system to exit maneuver's execution.

1 #speedSpeed Reference fp32_t – –

The value of the desired speed, in the scale specified by the "flags" field.

5 #zZ Reference fp32_t m –

The value of the desired z reference in meters.

9 #headingHeading Reference fp32_t rad –

The value of the desired heading angle, relative to true north, in radians, or, the value of the desired heading rate angle, in radians.

#References

Carried inline by: