DVL Rejection
DvlRejection
ID 358
- Payload
- 10 bytes
- Packet
- 32 bytes
- Source
- vehicle
- Category
- Navigation
When the vehicle uses Doppler Velocity Log sensor, this message notifies that a new measurement was locally rejected by the navigation filter.
#Fields
| Offset | Field | Type | Unit | Range | Description | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 0 | #typeType of velocity |
uint8_t |
Bitfield | – | This field represents the type of the rejected velocity.
|
||||||||||||
| 1 | #reasonReason |
uint8_t |
Enumerated | – | Reason for rejection. There are two types of DVL measurement filters. An Innovation filter checks the innovation between the current measurement and the previous measurement within a certain amount of time and an Absolute filter compares the measurement with an absolute threshold value. Those filters are tested using horizontal speed measurements, i.e., measurements in the x-axis and in the y-axis.
|
||||||||||||
| 2 | #valueValue |
fp32_t |
m/s | – | Value of the rejection. If it is an innovation rejection the value is the absolute difference between the previous accepted DVL measurement and the current one. If it is an absolute rejection the value is the current DVL measurement. |
||||||||||||
| 6 | #timestepTimestep |
fp32_t |
s | – | Timestep of the rejection. The timestep is 0 for an absolute rejection since it is an instantaneous reading. For innovation rejection it is the time difference between the previous accepted DVL measurement and the current one. |