Elevator Maneuver
Elevator
ID 462
- Payload
- ≥ 40 bytes, variable
- Packet
- ≥ 62 bytes
- Source
- ccu
- Category
- Maneuvering
The Elevator maneuver specifies a vehicle to reach a target waypoint using a cruise altitude/depth and then ascend or descend to another target altitude/depth. The ascent/descent slope and radius can also be optionally specified.
#Fields
| Offset | Field | Type | Unit | Range | Description | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 0 | #timeoutTimeout |
uint16_t |
s | – | The amount of time the maneuver is allowed to run. If the maneuver is not completed in the amount of time specified an error will be generated. |
||||||||||||
| 2 | #flagsFlags |
uint8_t |
Bitfield | – | Flags of the maneuver.
|
||||||||||||
| 3 | #latLatitude WGS-84 |
fp64_t |
rad | −π/2 … π/2 | WGS-84 Latitude. |
||||||||||||
| 11 | #lonLongitude WGS-84 |
fp64_t |
rad | −π … π | WGS-84 Longitude. |
||||||||||||
| 19 | #start_zStart Point -- Z Reference |
fp32_t |
m | – | Altitude or depth of start point. This parameter will be ignored if the 'NO_Z' flag is set, or if the 'START' flag is not set. |
||||||||||||
| 23 | #start_z_unitsStart Point -- Z Units |
uint8_t |
Enumerated | default
0 |
Units of the start point's z reference. 4 values from
|
0 | Z_NONE | None |
1 | Z_DEPTH | Depth |
2 | Z_ALTITUDE | Altitude |
3 | Z_HEIGHT | Height |
end_zEnd Point -- Z Referencefp32_tDepth or altitude for the end point. This parameter will be ignored if the 'NO_Z' flag is set.
end_z_unitsEnd Point -- Z Unitsuint8_t0Units of the end point's z reference.
4 values from ZUnits
0 | Z_NONE | None |
1 | Z_DEPTH | Depth |
2 | Z_ALTITUDE | Altitude |
3 | Z_HEIGHT | Height |
radiusRadiusfp32_tRadius for use in ascent/descent. If 0 the controller to should use a custom control strategy.
speedSpeedfp32_tManeuver speed.
speed_unitsSpeed Unitsuint8_t0Speed units.
3 values from SpeedUnits
0 | SUNITS_METERS_PS | Meters per second |
1 | SUNITS_RPM | RPM |
2 | SUNITS_PERCENTAGE | Percentage |
customCustom settings for maneuverplaintextCustom settings for maneuver.
#References
Member of Maneuver: it can be sent where that group is expected.
Carried inline by:
VehicleCommand.maneuvermessage · via ManeuverPlanManeuver.datamessage · via ManeuverManeuverResumed.man_listmessage-list · via Maneuver