IMCInter Module Communication
v5.5.11

Path Control State

PathControlState ID 410
Payload
81 bytes
Packet
103 bytes
Source
vehicle
Category
Guidance

Path control state issued by Path Controller.

#Fields

Offset FieldTypeUnitRangeDescription
0 #path_refPath Reference uint32_t – –

Unsigned integer reference of the desired path message to which this PathControlState message refers to. Path reference should only be set by a maneuver, not by path controllers.

4 #start_latStart Point -- Latitude WGS-84 fp64_t rad −π/2 … π/2

WGS-84 latitude of start point.

12 #start_lonStart Point -- WGS-84 Longitude fp64_t rad −π … π

WGS-84 longitude of start point.

20 #start_zStart Point -- Z Reference fp32_t m –

Altitude or depth of start point. This parameter will be ignored if the 'NO_Z' flag is set, or if the 'START' flag is not set.

24 #start_z_unitsStart Point -- Z Units uint8_t Enumerated
default 0

Units of the start point's z reference.

4 values from ZUnits
0Z_NONENone
1Z_DEPTHDepth
2Z_ALTITUDEAltitude
3Z_HEIGHTHeight
25 #end_latEnd Point -- Latitude WGS-84 fp64_t rad −π/2 … π/2

WGS-84 latitude of end point.

33 #end_lonEnd Point -- WGS-84 Longitude fp64_t rad −π … π

WGS-84 longitude of end point.

41 #end_zEnd Point -- Z Reference fp32_t m –

Depth or altitude for the end point. This parameter should be ignored if the 'NO_Z' flag is set.

45 #end_z_unitsEnd Point -- Z Units uint8_t Enumerated
default 0

Units of the end point's z reference.

4 values from ZUnits
0Z_NONENone
1Z_DEPTHDepth
2Z_ALTITUDEAltitude
3Z_HEIGHTHeight
46 #lradiusLoiter -- Radius fp32_t m –

Radius for loitering at end point. Will be 0 if no loitering is active.

50 #flagsFlags uint8_t Bitfield –

Path control state flags.

0x01FL_NEARNear Endpoint

Set if near the target endpoint.

0x02FL_LOITERINGLoitering

Set if loitering.

0x04FL_NO_ZNo Altitude/Depth control

Altitude/depth being controlled independently.

0x08FL_3DTRACK3D Tracking

3D-tracking is active.

0x10FL_CCLOCKWCounter-Clockwise loiter

Indicates that loitering, if active, is being done counter-clockwise. Otherwise, clockwise loitering should be assumed.

51 #xAlong Track Position fp32_t m –

Along-Track position value.

55 #yCross Track Position fp32_t m –

Cross-Track position value.

59 #zVertical Track Position fp32_t m –

Vertical-Track position value.

63 #vxAlong Track Velocity fp32_t m/s –

Along-Track velocity value.

67 #vyCross Track Velocity fp32_t m/s –

Cross-Track velocity value.

71 #vzVertical Track Velocity fp32_t m/s –

Vertical-Track velocity value.

75 #course_errorCourse Error fp32_t rad –

Course error value.

79 #etaEstimated Time to Arrival (ETA) uint16_t s –

Estimated time to reach target waypoint. The value will be 65535 if the time is unknown or undefined, and 0 when loitering.