IMCInter Module Communication
v5.5.11

Report Control

ReportControl ID 513
Payload
≥ 6 bytes, variable
Packet
≥ 28 bytes
Source
ccu, vehicle
Category
Vehicle Supervision

This message is sent to trigger reports to a destination system.

#Fields

Offset FieldTypeUnitRangeDescription
0 #opOperation uint8_t Enumerated –

Operation to perform.

0OP_REQUEST_STARTRequest Start of Reports

Request a system to periodically send reports through 'interface'. The destination system will reply with a STARTED command. Periodicity will be defined by the field 'period'. If applicable, the destination address is defined in field 'dst'.

1OP_STARTEDReport Started

The destination system will reply a message with this operation everytime a report is successfully started. The periodicity of reports is indicated in the field 'period' while the communication interface to be used is described in field 'interface'. If applicable, the destination address is defined in field 'dst'.

2OP_REQUEST_STOPRequest Stop of Reports

Request a system to stop dispatching reports through a given communication interface described in 'interface'. The destination system will reply with a STOPPED command. If applicable, the destination address is defined in field 'dst'.

3OP_STOPPEDReport Stopped

The destination system will reply a message with this operation everytime a scheduled report is successfully stopped in a defined communication interface. If applicable, the destination address is defined in field 'dst'.

4OP_REQUEST_REPORTRequest Single Reports

Request a system to issue a single report in a defined communication interface. The destination system will reply with a REPORT_ISSUED command. If applicable, the destination address is defined in field 'dst'.

5OP_REPORT_SENTSingle Report Sent

The destination system will reply a single report request with this operation.If applicable, the destination address is defined in field 'dst'.

1 #comm_interfaceCommunication Interface uint8_t Bitfield –

Communication interface to be used for reports.

0x01CI_ACOUSTICAcoustic

Use acoustic communications

0x02CI_SATELLITESatellite

Use satellite communications

0x04CI_GSMGSM

Use Global System for Mobile Communications

0x08CI_MOBILEMobile

Use mobile networks

0x10CI_RADIORadio

Use Radio telemetry

2 #periodPeriod uint16_t s –

Desired periodicity for scheduled reports.

4 #sys_dstDestination System plaintext – –

Destination Address to be filled where applicable. It should be interpreted differently depending on communication interface.