IMCInter Module Communication
v5.5.11

UamTxFrame

UamTxFrame ID 814
Payload
≥ 7 bytes, variable
Packet
≥ 29 bytes
Source
ccu, vehicle
Category
Acoustic Communication

This message shall be sent to acoustic modem drivers to request transmission of a data frame via the acoustic channel.

#Fields

Offset FieldTypeUnitRangeDescription
0 #seqSequence Id uint16_t – –

A sequence identifier that should be incremented for each request. This number will then be used to issue transmission status updates via the message UamTxStatus.

2 #sys_dstDestination System plaintext – –

The canonical name of the destination system. If supported, the special destination 'broadcast' shall be used to dispatch messages to all nodes.

var #flagsFlags uint8_t Bitfield –

Transmission flags.

0x01UTF_ACKAcknowledgement

On modems that support it, this flag shall be used to request an acknowledgment of reception from the receiving node.

0x02UTF_DELAYEDDelayed

On modems that support it, this flag shall be used to delay the frame transmission until the modem needs to transmit control data (e.g., acknowledgment of reception, etc).

0x04UTF_FORCEDForced

Ignore safety checks such as "transducer not connected".

var #dataData rawdata – –

The actual data frame to transmit. The data size shall not exceed the MTU of the acoustic modem.